How to Make a Mission Style Bookcase

Jun 11th

Mission style bookcase – also known as arts and crafts or artisan style – highlights, clean strong lines and robust construction. Plans for this shelf bookcase create the classic silhouette mission style, which is short and a little wide, with open sides lamas. Cut the oak in four positions measuring 1 1/2 inches by 1 1/2 inches and 32 inches long. Cut oak shelves measuring three inches by 11 3/4 inches by 40 inches long. Cut two more oak slats measuring centers 1 1/2 inches by 1 1/2 inches and 32 inches long.

Mission Style Bookcase Glass Door
Mission Style Bookcase Glass Door

Finish the cutting part of mission style bookcase by sawing four oak slats measuring its 4.3 inches by 4.3 inches by 32 inches long. Check each of its four seats in the center of the posts in these places: 3 inches from the bottom, 12 inches and 12 centimeters marked that mark. Make similar marks on the sides of all the slats. drill holes pilot five equally spaced across the edges on both sides of the three short shelves. Drill pilot holes through your messages and lamas where the markings.

12 Photos Gallery of: How to Make a Mission Style Bookcase

Image of: Mission Style Bookcase Glass Door
Image of: mission style bookcase headboard
Image of: Antique Mission Style Bookcase
Image of: Mission Style Bookcase Furniture
Image of: Mission Style Bookcase Models
Image of: Mission Style Bookcase Style
Image of: Modern Mission Style Bookcase
Image of: Oak Mission Style Bookcase
Image of: Rustic Mission Style Bookcase
Image of: Small Mission Style Bookcase
Image of: The Mission Style Bookcase
Image of: Wooden Mission Style Bookcase
 
Related  Stylish and Functional Deep Bookcase

Secure with screws an edge of a shelf below the pilot hole on a pole, using the outermost hole in the edge of the shelf for mission style bookcase. Attach another job to another hole in the outer edge of the platform. Attach a cross bar in the middle hole in the edge of the platform, using the bottom hole and the pilot slat, and attach two laths pilot holes left on the edge of the platform using the lowermost holes in the slats.